Using plaintext protocol, command format error; command parse error;
WinRobotics opened this issue · 4 comments
Hi,
I am facing some issues with using the UART to manually send serial commands into the Robomaster EP.
I am facing this issue when:
[input] command;
[output] ok;
[input] chassis move x 0.1 y 0.0 z 0.0;
robot moves 0.1m
[input] chassis move x 0.1 y 0.0 z 0.0; [again]
[output] command formart error; command parse error
i have checked the documentations inside the SDK but nothing was mentioned. Wondering if there is a need to send back a "ACK/OK" kind of message back to the robomaster ? or is there some timing conditions need to be fulfilled
Might have been a typo, but your last command is missing a semicolon (;) at the end.
…
On Thu, Dec 23, 2021 at 2:06 PM Sherwin Fun @.> wrote: Hi, I am facing some issues with using the UART to manually send serial commands into the Robomaster EP. I am facing this issue when: [input] command; [output] ok; [input] chassis move x 0.1 y 0.0 z 0.0; ------------------------------ robot moves 0.1m [input] chassis move x 0.1 y 0.0 z 0.0 [again] [output] command formart error; command parse error i have checked the documentations inside the SDK but nothing was mentioned. Wondering if there is a need to send back a "ACK/OK" kind of message back to the robomaster ? or is there some timing conditions need to be fulfilled — Reply to this email directly, view it on GitHub <#58>, or unsubscribe https://github.com/notifications/unsubscribe-auth/AAO22HYSWILJ2XXM52FLBWTUSOMO3ANCNFSM5KVSIFKA . Triage notifications on the go with GitHub Mobile for iOS https://apps.apple.com/app/apple-store/id1477376905?ct=notification-email&mt=8&pt=524675 or Android https://play.google.com/store/apps/details?id=com.github.android&referrer=utm_campaign%3Dnotification-email%26utm_medium%3Demail%26utm_source%3Dgithub. You are receiving this because you are subscribed to this thread.Message ID: @.>
Hi Brunoga,
It's my bad that i made a typo mistake in the post. But there wasn't any typo in the actual one
Hi,
Just an update, i realized that when i was doing testing. i placed the robomaster on a wooden block for it wheels to be free rolling for me to run my codes. I realized that this cause the robomaster to go haywire and when i placed it on the floor it was working quite fine abelit some timing issue when inputting in "chassis drive " command.
I think this has to do with the robomaster taking in the in bulit imu for some closed loop feedback controls. Thus, not getting the correct acceleration causes it to go haywire.
I realized that when i am testing, while using chassis speed mode. Even giving it x 0 y 0 z 0 speed. it will still try move a bit. Not sure why. Will do more testing and further update.
Managed to solve the issue, realized that the robomaster imu might be drifting. Thus, when even a zero speed command is issued. The robot still rotates slightly. I have played with the Z value by giving a initial 1.15 to compensate for the drift.
Hope this will help anyone working on the robomaster uart 3rd party software