/*
Version: V1.0
Author: Vincent
Create Date: 2021/11/22
Note:
*/
[toc]
Product Link :esp32-s2-parallel-tft-with-touch-3-5-ili9488
Wiki Link : ESP32-S2 Parallel TFT with Touch(3.5'')
The 3.5" 320x480 TFT LCD driver is ILI9488, it uses 16bits parallel line for communication with ESP32-S2, the main clock could be up to 20MHz, make the display smooth enough for videos; You can freely use some of Mabee pins(A I2c and a IOs) with the breakout connectors, to connect the ESP32-S2 display with sensors/ actuators, suitable for IoT applications.
- Integrated ESP32-S2 with 2.4G WiFi
- Wi-Fi Protocols: 802.11b/g/n(802.11n up to 150Mbps),A-MPDU and A-MSDU aggregation and 0.4us guard interval support
- Wi-Fi Frequency range: 2.402GHz - 2.483Ghz
- Arduino Compatible: You can play it with Arduino IDE
- LCD 3.5 inch Amorphous-TFT-LCD (Thin Film Transistor Liquid Crystal Display) for mobile-phone or handy electrical equipment
- LCD Driver: ILI9488(16bits parallel line)
- LCD Resolution: 320*480
- FT6236 Series ICs are single-chip capacitive touch panel controller IC with a built-in 16 bit enhanced Micro-controller unit (MCU)
- NS2009: A 4-wire resistive touch screen control circuit with I2C interface, which contains A 12-bit resolution A/D converter
- Power supply: 5V, Type-C USB
- Micro SD card slot on the board
- Dual USB Type-C: one for native USB and one for USB-to-UART
- Two Mabee interfaces
- Board size: 66mm * 85mm
- Install board : ESP32 .
- Install library : LovyanGFX library.
- Edit the code based on the touch screen. If you use resistive screen, choice NS2009_TOUCH. If you use capacitive screen, choice FT6236_TOUCH.
- Use type-c use cable connect USB-TTL to PC.
- Upload codes, select "ESP32-S2 DEV Module" and "UART0"
Factory firmware. First run the boot self-test to check the hardware. Press down the middle of the touch screen as prompted to display a LOGO picture on the SD card. Finally, print the touch coordinates in the serial port.
Three frame rate tests and SD card read and write tests.
- FillScreen
- Graph
- Touch
- PWM_backlight
Use pwm control screen back light.
The display of 5 display effects is modified from Lovyan's example. There are also two homemade demonstration videos: ultrasonic ranging and line charts.
Receive TXT and BMP files over WIFI and display them on the screen.
Added a WiFi bulletin board app. You can upload and browse files in the SD card through the web page. And the latest uploaded BMP or TXT display on the 3.5-inch screen.
- Library Install:esp32-micro-sdcard and esp32-webserver
- Upload .\example\wifi_img_16\wifi_img_16.ino
- Insert the SD card and power on.
- Enter the IP address on the screen in your browser.
- Select TXT or BMP to be uploaded. BMP must be 480 x 320 pixels, 24 bits.
- Upload.
- Wait seconds, the content is displayed on the screen.