Bifrost is a temporal derainbowing filter created by Fredrik Mellbin.
The original Avisynth plugin (version 1.1) worked on the whole frame or not at all. This version works on blocks, meaning that static parts of the image can be processed even if something moves on screen.
The VapourSynth plugin will accept any 8 bit YUV formats. The Avisynth plugin is still limited to YV12.
bifrost.Bifrost(clip clip[, clip altclip=clip, float luma_thresh=10.0, int variation=5, bint conservative_mask=False, bint interlaced=True, int blockx=4, int blocky=4])
altclip
Bifrost will copy from this clip the chroma of the blocks it can't process. This allows moving blocks to be processed with some other filter. altclip must have the same format, dimensions and length as clip.
luma_thresh
Blocks where the luma changes less than this are considered static and may be processed.
variation
Controls how big a chroma change must be in order to be considered a rainbow. Increasing this can reduce false positives.
conservative_mask
If true, only pixels detected as rainbows will be processed. Otherwise, pixels that have rainbows above and below them will also be processed.
interlaced
If true, SeparateFields, DoubleWeave and SelectEvery will be invoked in order to process the top and bottom fields separatedly.
blockx
blocky
The dimensions of the blocks. Smaller is probably better. The default 4×4 should be good enough.
Note: If the dimensions of the image aren't divisible by blockx and blocky, the right and/or bottom edges won't be processed. Pad or crop the image before using Bifrost.
When dealing with telecined material you must determine if the rainbows were added before or after the telecine process. Find a scene with clearly visible rainbows and use the following:
src = your.Source() separated = std.SeparateFields(src) even = std.SelectEvery(separated, 2, 0)
If the rainbows change every frame, they were added after telecine. If there is a duplicate every five frames, they were added before.
First you must fix the telecine, then use Bifrost in progressive mode:
ret = d2v.Source("rainbows1.d2v")
ret = vivtc.VFM(ret, order=1, chroma=False, mchroma=False)
ret = vivtc.VDecimate(ret, chroma=False)
ret = bifrost.Bifrost(ret, interlaced=False)
In this case, Bifrost should be used in interlaced mode, right after the source filter:
ret = d2v.Source("rainbows2.d2v")
ret = bifrost.Bifrost(ret, interlaced=True)
# ivtc here
./autogen.sh ./configure make
DLLs for VapourSynth and for Avisynth 2.5.8+ can be found in the "releases" section.