This README.md uses the Markdown syntax. The MarkDownDemo tutorial shows how various elements are rendered. The Bitbucketdocumentation has more information about using a README.md.
$ git clone https://bitbucket.org/xengiennering/sn3d-project.git
$ cmake CMakeList.txt
$ ls -al
$ make sn3d_install
$ cd /SN3D/sn3d-project
$ make sn3d_service_install
$ sudo reboot
$ journalctl -u SN3D_Bootloader.service
$ journalctl -u SN3D.service
$ make sn3d_install
- SN3D Repository install to root directory => /SN3D/sn3d-project
.
$ make sn3d_service_install
- SN3D.service & SN3D_Bootloader.service install to systemd.
$ make sn3d_resize2fs_install
- SN3D root filesystem partion extend all partition.
$ make start
- SN3D.service restart.
$ make stop
- SN3D.service stop
$ make all
- Build project.
$ make clean
- Clean project. ( not remove cmakeFiles just build file. )
$ make all_clean
- build file and all cmake file is remove.
$ make gdb
- SN3D start with GDB. First do $ make stop
.
$ make run
- SN3D start without GDB. First do $ make stop
.
$ make doxygen
- make SN3D API Html file path(/SN3D/sn3d-project/doc/html
)
$ cmake CmakeList.txt
The leading developers of Sprinter are currently Kliment and caru, though many others contribute with their patches. This is a firmware for RAMPS and other reprap single-processor electronics setups. It supports printing from SD card, active heatbed control, and ATmega internal pullups. This work is licensed under the GNU GPL v3 or (at the user's discretion) any later version. It is based on Tonokips's firmware, which was licensed under GPL v2 or later.
See Sprinter on Github.
M106 S255
- Turn on UV lamp.
M107
- Turn off Uv lamp.
M92
- Set current position.
G1
- Move to by prameter.
G28 Z0
- Homing.
or More detail & other G Code click => Reprap G Code Sheet
-
- NX4024T032_011R
- NX4827T043_011R
- NX8048T050_011R
- NX8048T070_011R
or More detail click => Nextion HMI Solution
-
-
-
EUC-KR - Need covert to EUC-KR from UTF-8 format.
-
-
- Sprinter
- Raspberry Pi 3 B+
- Ramps Board
- Memory Test.
- PNG image checker & notify to user.
- Info screen design.
- 8.9 Inch Display Test
- USB mount event.
- Time indicate timer stoped when printing ( but it restart when resume ).
Step 1. Install Python 3
Step 2. Install pip3 or pip with a python 3
Step 3. Install pyinstaller
raspberry pi first boot auto resize
add line "/boot/cmdline.txt"
$ sudo vim /boot/cmdline.txt
add quiet init=/usr/lib/raspi-config/init_resize.sh
behine rootwait.
rootwait quiet init=/usr/lib/raspi-config/init_resize.sh
and follow this command lines.
$ sudo wget -qO /etc/init.d/resize2fs_once https://github.com/RPi-Distro/pi-gen/raw/dev/stage2/01-sys-tweaks/files/resize2fs_once
$ sudo chmod +x /etc/init.d/resize2fs_once
$ sudo systemctl enable resize2fs_once
and make image file or reboot.