BK7231 GUI Flash Tool

BK7231 GUI Flash Tool a simple Windows application that allows you to flash the OpenBK firmware to Beken chipset (BK7231T or BK7231N) based devices without having extensive programming knowledge.

Futhermore, it automatically creates an original firmware backup, so you can submit the original firmware dump for futher analysis
❗ NOTE: The flash dump may contain your SSID and pass if the device was paired at the time of the backup

Compiling and Running on Linux

It should be possible to compile and run this tool on Linux by using Mono. Mono is an open-source implementation of the .NET Framework which is also sponsored by Microsoft.

Please note that if you're opting to run this tool under Linux, it is highly recommended for you to install Mono using your distro's package manager.

Once it's installed, you can compile this software by executing xbuild on the project directory. To execute the program, you can simply execute the following command:

mono BK7231Flasher/bin/debug/BK7231Flasher.exe

Brief usage instructions

Connect UART to USB converter to Beken TXD1/RXD1
Start flasher tool
Select N or T platform
Click "Download latest from web" to get firmware binary
Click "Do backup and flash new"
Reset/repower Beken
Tool will do both read and flash in one row.
Done!

No command line and no strange arguments required.

Detailed usage instructions

Download and unpack executable from Releases tab on the right
Prepare flashing circuit for BK7231 (both T and N)
- Get a USB to UART bridge with 3.3V voltage signals
- Connect the Bridge RX to Module TXD1, and Bridge TX to Module RXD1
- If necessary, solder a wire to the CEN pad (if you want to RESET through shorting CEN to ground)
- Power the device from either the bridge or an external power source. All Beken based modules require 3.3v.
  ⚠️ NEVER try hacking devices while connected to mains power!
Open our flasher:

Select proper platform - BK7231T or BK7231N
Select your COM port of USB to UART converter
Click "Download latest from Web" to get proper binary file
Wait for download to finish

Close download window
Click "Backup and flash new"
When the log window is waiting for "Getting bus", do a device reboot/reset. You can do this in two ways, choose one:
- Option A: short CEN to GND for 0.25s (it is tricky to get this right, requires precise timing)
- Option B: power off and on device (of course, it should not be connected to mains, use your own safe 3.3V power supply that can supply enough current)

It will begin reading (it does first backup, then write)

After reading, it will start the new firmware erase

And then, automatically, write:

Done:

Firmware access point show appear now. Connect to it and enter 192.168.4.1 configuration page.
Remember that saved firmware backup is in the "backups" dir

CRC Mismatch?

CRCs are calculated correctly for both N and T. If you get CRC mismatch, you are most likely selecting a wrong chip type.

Can't auto download firmware?

Firmware download will not work on systems without newer TLS version required by Github. You can always manually download release from here: https://github.com/openshwprojects/OpenBK7231T_App and put into firmwares bin, then restart flasher.