ESP32 + LAN8720 ethernet
Connect unmodified LAN8720 module.
#GPIO00 - EMAC_TX_CLK : nINT/REFCLK (50MHz)
#GPIO16 - SMI_MDC : MDC (relocateable)
#GPIO17 - SMI_MDIO : MDIO (relocateable)
#GPIO19 - EMAC_TXD0 : TX0
#GPIO21 - EMAC_TX_EN : TX_EN
#GPIO22 - EMAC_TXD1 : TX1
#GPIO25 - EMAC_RXD0 : RX0
#GPIO26 - EMAC_RXD1 : RX1
#GPIO27 - EMAC_RX_DV : CRS
#GND : GND
#3V3 : VCC
ESP32 will be unreliable to start but after few attempts of power OFF/ON or reset it will boot and respond to ping and allow REPL etc over wired ethernet.
Start it just as this (can be put in main.py)
import lan8720
It will request IP address by DHCP. Edit file "lan8720.py" to set fixed IP.
import network
from machine import Pin
lan = network.LAN(mdc=Pin(16), mdio=Pin(17), power=None, id=None, phy_addr=1, phy_type=network.PHY_LAN8720)
lan.active(True)
# by default (no parameters), ifconfig() will request IP from DHCP
lan.ifconfig()
# set fixed IP (address, netmask, gateway, dns)
#lan.ifconfig(('192.168.0.190', '255.255.255.0', '192.168.0.1', '192.168.0.1'))