This collection aim for some stm32f103RC basic example. I use customized board in these exmaples.
##Prerequisite
sudo apt-get install automake* libtool libusb-1.0-0-dev
git clone http://github.com/texane/stlink.git
cd stlink
./autogen.sh
./configure --prefix=/usr
make
sudo make install
sudo cp 49-stlinkv2.rules /etc/udev/rules.d/
sudo add-apt-repository ppa:terry.guo/gcc-arm-embedded
sudo apt-get update
sudo apt-get install gcc-arm-none-eabi
##Demo Introduction
1.GPIO toggling
This demo shows how to toggle your GPIO(PA0 , PA1).
2.USART
I use PA10 as USART1 RX, PA9 as USART1 TX.
ehco: demo let MCU transmit same message as user typing. MCU will transmit message until USART receive data from PC. This method also is called polling.
echo_interrupt: acts like echo. But MCU will interrupt instead of polling.
repeat_send just is a simple transmitting demo. MCU will continuously send message to PC.
printf include a portable printf function
retarget_printf : Because the my printf have some floating point issue, I let Makefile link software floating point with newlib-nano printf.
3.[ADC]
This demo still have some problem now.
4.[EXTI]
This demo shows how to use External interrupt/event controller to handle incoming signal. In this case, these 5 GPIO connect to a switch.
5.[I2C]
I2C with MPU6050. You will see acceleration and angular rate through comport.
6.[PWM]
This demo shows how to drive a servo motor
7.[TIMER]
Toggling GPIO by more accurately time base