Native extension gem for secp256k1 ECDSA and Schnorr signatures. Wraps libsecp256k1 without the need for FFI.
- Native extension gem wrapping libsecp256k1, no FFI.
- Schnorr signature support.
libsecp256k1 is an extremely optimized implementation of public key derivation, signing, and verification with the secp256k1 elliptic curve. It comes with its own set of benchmarks, but from benchmarking done by Peter Wuille it is ~4.9x faster than the OpenSSL implementation of the same curve. It is the only library that provides constant time signing of this curve and has been deployed as part of Bitcoin since v0.10.0
Natively wrapping the library in an extension gem means users don't have to worry about compiling or locating the library, unlike many FFI based gems.
The simplest installation:
gem install rbsecp256k1
If you want to use your system version of libsecp256k1 rather than the bundled
version use the --with-system-libraries
flag:
gem install rbsecp256k1 -- --with-system-libraries
Install the dependencies for building libsecp256k1 and this library:
sudo apt-get install build-essential automake pkg-config libtool \
libffi-dev libssl-dev libgmp-dev python3-dev
NOTE: If you have installed libsecp256k1 but the gem cannot find it. Ensure
you have run ldconfig
so that your library load paths have been updated.
Dependencies for building libsecp256k1 and this library:
brew install automake openssl libtool pkg-config gmp libffi
See rbsecp256k1 documentation for examples and complete list of supported functionality.
To clone the repository and its submodules you'll need to the following:
git clone git@github.com:etscrivner/rbsecp256k1.git
Development is largely facilitated by a makefile. After download you should run the following command to set up your local environment:
make setup
To compile the extension gem run the following (this is required to run tests):
make build
make test
To test with recovery functionality disabled run:
make test WITH_RECOVERY=0
You can similarly uninstall the local gem by running the following:
make uninstall
To clean up and do a fresh build:
make clean
To run the YARD documentation server:
make docserver