With Ramps Steppers Not Working !
gumush opened this issue · 2 comments
gumush commented
Demo of Accelstepper libraries is working with multiple step motors.
ifndef MOTHERBOARD
//#define MOTHERBOARD POLARSHIELD
define MOTHERBOARD RAMPS14
//#define MOTHERBOARD TFTSHIELD
endif
//#define USE_LC
Check pins of motors with
define DEBUG
With this firmware motors just have a small buzzing.
euphy commented
Insufficient information, what firmware (version, source)? What commands are you sending, what are you expecting, are you receiving any messages back from the machine etc. What have you done so far. What setup guide are you following, what have you already tried.
Please think about what information I would be likely to need to be able to help diagnose a problem. And give it.
euphy commented
I'm closing this issue as not defined.