Most libs are added in "platformio.ini", but WifiManager is (as we speak) only released on 0.16.
Therefore WifiManger is added manually in libs from:
https://github.com/tzapu/WiFiManager
Cause we're using the wm.getWebPortalActive() function.
https://github.com/crankyoldgit/IRremoteESP8266/tree/master/examples https://www.instructables.com/Easiest-ESP8266-Learning-IR-Remote-Control-Via-WIF/
https://www.esp8266.com/viewtopic.php?p=90383#p90383
https://www.cnx-software.com/2017/04/20/ karls-home-automation-project-part-4-mqtt-bridge-updated-to-use-ys-irtm-ir-receiver-transmitter-with-nodemcu/ https://github.com/mcauser/micropython-ys-irtm
https://www.electronicwings.com/nodemcu/nodemcu-gpio-with-arduino-ide
Quote:
Some of the GPIO pins are used while booting, so Pulling this pin HIGH or LOW can prevent NODEMCU from booting
GPIO0: It oscillates and stabilizes HIGH after ~100ms. Boot Failure if pulled LOW
GPIO1: LOW for ~50ms, then HIGH, Boot Failure if Pulled LOW.
GPIO2: It oscillates and stabilize HIGH after ~100ms, Boot Failure if Pulled LOW.
GPIO3: LOW for ~50ms, then HIGH.
GPIO9: Pin is HIGH at Boot.
GPIO10: Pin is HIGH at Boot.
GPIO15: LOW, Boot failure if Pulled HIGH
GPIO16: HIGH during Boot and Falls to ~1Volt.
https://www.esp8266basic.com/editor-interface.html
Find inspiration here: https://www.instructables.com/Easiest-ESP8266-Learning-IR-Remote-Control-Via-WIF/
IR codes: http://www.righto.com/2009/08/multi-protocol-infrared-remote-library.html
Arduino IR Remote: https://github.com/Arduino-IRremote/Arduino-IRremote