OrangeCrab
ECP5 FPGA Feather development board.
Latest Revision:
Previous Revisions:
What is it?
There aren't many OSHW ECP5 boards available. Given that this FPGA is fully supported by an open source toolchain I decided to create one. In order to make use of the DDR3L support the ECP5 has, I've added some DDR3L memory. The board matches the feather format
Hardware Overview
- Lattice ECP5-25F FPGA in csfBGA285 package
- 24 K - Look Up Tables
- 1008 Kb - Embedded Block RAM
- 194 Kb - Distributed RAM
- 28 - 18x18 Multipliers
- PLLs: 2
- Internal oscillator
- Flexible I/O for DDR3 Memory Support
- DDR3L Memory
- 128 Mbytes (1Gbit)
- 64M x16
- 1.35V low voltage operation
- Micro USB connection
- Full-speed (12Mbit) USB with direct connection to FPGA
- Non-volatile Storage
- 128Mbit QSPI FLASH Memory
- Bootloader (First 4Mbits)
- User Bitstream
- User storage (Firmware/MSC backend/etc)
- QSPI compatible
- MicroSD socket
- 4bit SD interface (CK, CMD, DAT0-3)
- 128Mbit QSPI FLASH Memory
- Power supply
- High effeciency DCDC for main supplies
- Battery charger (100mA), with charge indicator LED
- LiPo battery connector (PH type)
- 48MHz onboard oscillator
- Standard 0.05" JTAG connector
- User I/O
- 1x Button
- 1x RGB LED
- 20x I/O on 0.1" headers
- Analog System
- Analog Mux
- SAR ADC, external RC / input comparator of FPGA
- Digital bypass
- Internal channels for supply monitor
- Battery voltage sensing
- Feather Format Board
- Dimensions: 22.86mm x 50.8mm (0.9" x 2.0")
Licence
- Hardware in this repository is licenced under CERN OHL v1.2
- Gateware/Software/Firmware in this repository is licenced under MIT unless otherise indicated
OSHW
This board is an OSHWA approved design: AU000006