OctoPrint-heated-chamber
This plugin controls the enclosure temperature via a temperature sensor, a heater and the enclosure air extraction fan.
At the moment it only supports those:
- The DS18B20 temperature and humidity sensor
- A PWM-controlled fan
- An active-low GPIO-controlled relay heater
The settings are still a draft and not working
Setup
Install via the bundled Plugin Manager or manually using this URL:
https://github.com/filosganga/OctoPrint-heated-chamber/archive/master.zip
Configuration
You can configure the frequency at which the plugin runs the duty cycle, by default every 5 seconds.