pixElv
PixElv aspires to be a high-performance screen capture tool, although its success in this endeavor is not above questioning. It leverages DXGI duplication functionality and hardware encoding support via on Media Foundation. The program is designed for efficient capture of raw and compressed output from your monitor, with an emphasis of trying to get all of the frames, which is quite a challenge.
Features
- Screen capture using DXGI monitor duplication
- Output in raw (B8G8R8A8_UNORM (RGB24) with stripped alpha) and compressed formats (h264, nv12)
- Hardware encoder support using Media Foundation (milage may vary).
- AMF and NVENC have been tested and confirmed to work.
Usage
PixElv.exe -monitor [index] -fps [framerate] -delay [seconds] -comp [0 or 1] -frames [number] -duration [seconds] -bitrate [mbps] -path [output path]Parameters
-monitor: 0-based index of the monitor to capture. Default is 0 (primary monitor).
-path: Output file path. If blank or not specified, it will write the file to the location your current directory (pwd to check).
-fps: Framerate for the output. This must match the monitor's refresh rate. Default is 60. Anythiung but 60 is untested, and unlikely to work well.
-delay: Delay in seconds before starting capture. Default is 3 seconds.
-comp: Set to 1 for compressed (H.264) output, 0 for raw RGB24 output. Default is raw output.
-bitrate: Set the VBR bitrate in mbps, 30 = 30 mbps (which is the default)
-frames: Number of frames to capture. In frames, obviously. 60 frames in a sec usually.
-duration: Duration of capture in seconds. Multiplied by fps to determine the number of frames to capture.
If neither -frames nor -duration are specified, the default is 300 frames (5 seconds at 60fps). If you specify either to 0, it should run for 12 hours, leaving you free to stop it at your whim (ctrl+c).
You should be able to cancel the capture early by hitting ctrl+c.