/fprime-system-reference

A full-system reference for F´ projects.

Primary LanguageC++Apache License 2.0Apache-2.0

F´ System Reference: A Reference Project Using an Open-Source Flight Software Framework

Table of Contents

  1. About The Project
  2. Getting Started
  3. Device Wiring

About The Project

The purpose of this project is to provide an example embedded software application that uses the F´ framework. The System Reference consists of several subsystems:

  • Payload
  • Guidance Navigation and Control (GNC)
  • Communication

Built With

Getting Started

Requirements

The system reference depends on several items, before the user attempts to clone the project they should ensure that they have the listed requirements below before proceeding.

Requirements:

  1. Linux OS
  2. libcamera
    • For libcamera dependencies, please see the list here. Ensure that the required dependencies are installed before building libcamera (steps for building libcamera are in the Setup libcamera) section below.
    • In addition, will need pkg-config installed
  3. F Prime Environment
    • Python virtual environment with fprime-fpp, fprime-tools, and fprime-gds installed
  4. Cross-Compilation tools for ARM
  5. Raspberry Pi with Bullseye OS
    • In order to run the System Reference with libcamera, Bullseye OS is required. In addition, the firmware version may need to be upgraded in the event the system is configured to use the legacy camera stack.

Clone the F´ System Reference

git clone https://github.com/fprime-community/fprime-system-reference.git

Setup libcamera

libcamera is a library that provides a C++ API to applications that enables them to configure Raspberry Pi cameras and request image frames. The steps below cover how to build libcamera (for both native linux and ARM Linux), as well as how to build the System Reference with libcamera included.

Build libcamera

In order to run the camera subsystem, libcamera first has to be built. See the Compiling libcamera for Native Linux guide for steps on how to build libcamera for native Linux. Otherwise, if you are looking to run the System Reference on ARM Linux, see the Compiling libcamera for ARM Linux guide in order to cross-compile the library.

Building the System Reference

Building the System Reference with libcamera

Once the libcamera library is built, you can build the System Reference with libcamera included. This is required in order to run the camera subsystem, without doing so, the System Reference will not detect a camera and configure, process, or save images. For steps on how to build the System Reference with libcamera, see the guide here.

Building the System Reference (no libcamera)

To build the System Reference without libcamera, in a terminal run the below commands.

Note: Without libcamera, the System Reference will not detect a camera and configure, process, or save images.

For Native Linux:

fprime-util generate
fprime-util build

If compiling for ARM Linux, see the steps in the Cross Compilation Tutorial.

Upload to the Raspberry Pi

To run the ground system:

fprime-gds -n --dictionary raspberrypi/dict/SystemReferenceTopologyAppDictionary.xml

To copy the binary to the Raspberry Pi

scp build-artifacts/raspberrypi/bin/SystemReference pi@<YOUR RASPBERRY PI IP ADDRESS>:~

Running System Reference on the Raspberry Pi

After logging into the Raspberry Pi via SSH, you can run the Ref deployment as follows:

./SystemReference -a <ground system ip> -p 50000

Examples

  • Camera Component Tutorial - Tutorial on how to capture frames, downlink the image data to the ground, and how to process it as PNG or JPEG.

RPI Wiring

wiring diagram