3018 cutter comp
mg-jones-uk opened this issue · 2 comments
mg-jones-uk commented
Hi i have a 3018 but can not seem to input cutter comp, it doesnt recognize G41 G42 or where to put in cutter dia, help
fra589 commented
Hi @mg-jones-uk,
Cutter radius compensation (G41 / G42) is not supported by Grbl.
Cutter radius is generally defined by the FAO software.
@++;
Gauthier.
mg-jones-uk commented
Thankyou for the reply, I had my suspicions
…
On Feb 3, 2023 at 6:40 PM, <Gauthier Brière ***@***.***)> wrote:
Hi @mg-jones-uk (https://github.com/mg-jones-uk),
Cutter radius compensation (G41 / G42) is not supported by Grbl.
Cutter radius is generally defined by the FAO software.
@++;
Gauthier.
—
Reply to this email directly, view it on GitHub (#317 (comment)), or unsubscribe (https://github.com/notifications/unsubscribe-auth/A5UZJUZ4PKQUXVT7JEIWAV3WVVGLHANCNFSM6AAAAAAUQE6C54).
You are receiving this because you were mentioned.Message ID: ***@***.***>