Ability to apply setup values to multiple axes

[francotiveron]

this would be very useful since we frequently setup many of the same axes. having the ability to save and recall an axis config has been useful, but this would eliminate the need to press and hold on every axis. I am not sure the best way to accomplish this though since the setup screen is already getting crowded.

[francotiveron]

@pkelm1 Proposal
When Load is clicked, a popup appears allowing to select multiple motor and groups (only if enabled). This popup has two button (Confirm and Cancel). The motor/group under editing is pre-selected in the popup

[pkelm1]

Sounds perfect

[francotiveron]

Selection popup on Save settings

The following parameters are applied to all selected axes on save