garethky/PrusaSlicerPressureAdvanceCalibration

Issues

• Incorrect settings extracted from Prusa (2.8.1) Sliced gcode

  #22 opened 2 months ago by infinisean
  1

• [QUESTION] M900 vs. M572 - Prusa MK3.5 Firmware 6.0.3

  #20 opened 6 months ago by artistassembly
  8

• Wrong gcode generated for the Mk3.9s

  #21 opened 3 months ago by VorpalBlade
  3

• Invalid value for zhop instruction

  #16 opened 6 months ago by mayty
  3

• Use external perimeter acceleration for test acceleration

  #18 opened 8 months ago by npburns224
  0

• Use printing temperature instead of first layer temperature for test

  #19 opened 8 months ago by npburns224
  0

• Calibration with Filaments which need slow speeds/are limited by volumetric flow rather than print speed

  #17 opened 9 months ago by Unostot
  1

• Missing ;AFTER_LAYER_CHANGE comment.

  #13 opened 10 months ago by mottld
  6

• ERROR "nil" is not a number

  #15 opened 10 months ago by misisl
  3

• What should we do when First Layer temp and Temp don't match?

  #7 opened a year ago by garethky
  2

• Automatically shink the size of the test pattern for small printers

  #9 opened a year ago by garethky
  0

• Support for OrcaSlicer?

  #12 opened a year ago by kozross
  4

• Test pattern generation failed: No max Value found, all values are null!

  #14 opened a year ago by Disane87
  1

• Consider switch to Andrew Ellis more compact test pattern

  #11 opened a year ago by garethky
  1

• Support .bgcode files

  #6 opened a year ago by garethky
  2

• Connect numbers and pattern to make print removal easier

  #8 opened a year ago by garethky
  0

• Support Adaptive Bed Mesh

  #4 opened a year ago by garethky
  2

• Add Klipper Support

  #1 opened a year ago by garethky
  3

• Pressure Advance UX is too complicated

  #2 opened a year ago by garethky
  1

• Add M73 for Completion percentage UX

  #5 opened a year ago by garethky
  0

• Add Support for Round Beds/Delta Printers

  #3 opened a year ago by garethky
  0