The ctl.sh script provides commands that are useful to control the services
$ ./ctl.sh help
Control script for docker-compose services
Usage: ctl.sh <command>
Commands:
start Starts all services
stop Stops all services
restart Restart all services
reset Stops and Starts all services
logs Shows the docker logs
status Shows the services status
init Initializes the volumes and copies configuration files to the volumes.
This is only needed the first time!
help Shows this help page
The behavior of the init command varies from service to service. This behavior must be adjusted in ctl.sh depending on the service. Otherwise, an error message appears when executing the init command. The use case for initializing is to create the volumes and copy configuration files from etc into them so that they can be edited afterwards.
After executing the init command, the configuration files must be adjusted in most cases. This should only happen in the volumes folder and not in the etc folder. Otherwise, sensitive data may be pushed upstream.
The following table gives an overview of which files must be adjusted.
| Value | File |
|---|---|
| SECRET | turnserver.conf |
| REALM | turnserver.conf |
| EXTERNAL_NAT_IPv4_ADDRESS | turnserver.conf |
The versioning of the services as well as the domain name settings are done via an .env file which is automatically read by docker-compose. For this, the env.example should be copied and adapted. It should be noted that no secrets should end up in the .env.
Secrets should be created in a file that contains only the secrets for the corresponding service and grouped in the secrets folder. An example for this is service.secrets.example. Please note that the file permissions should be as restrictive as possible.
git remote add template git@github.com:Giom-fm/docker-service.git
git pull template main --allow-unrelated-histories