A simple serial/tcp comm program intended for use with (and on) embedded
systems. Supports telnet and high-character locale mapping.
--------------------------------------------------------------------------------
Usage:
nanocom [options] /dev/ttyX|host:port
Connect current tty to specified target, which is either a serial device (if
target contains a '/') or a TCP host (if target contains a ':').
Options:
-b - backspace key sends DEL instead of BS
-d - toggle serial port DTR high on start
-e - enter key sends LF instead of CR
-f file - log console output to specified file
-h - display unprintable characters as hex
-H - display all characters as hex
-i - display high-bit characters as CP437
-I charset - character set for -i, instead of CP437 ('iconv -l' for list)
-l mS - flush characters after first connect until idle for specified mS
-L mS - also flush on reconnect
-n - don't force target tty to 115200 N-8-1
-r - try to reconnect target if it won't open or closes with error
-s - display timestamps
-S - display date+timestamps
-t - enable telnet in binary mode
-T - enable telnet in ASCII mode (handles CR+NUL)
-x command - execute FX command after first connect
-X command - also execute on reconnect