AdScanerTrg - relay control from external BLE sensors for temperature, humidity, lighting, motion, reed switch. A repeater of BLE advertising packages.
Used SoC TLSR8266 or TLSR825x (module: JDY-10, E104-BT05, TB-03F, TB-04, ...)
Controls three relay outputs:
- Switching on at a given temperature and / or humidity with hysteresis.
- Switch the lamp at a given level of illumination and / or motion detection.
- Repeater of the state of the reed switch.
Supported BLE sensors devices: LYWSD03MMC, CGG1-M, MHO-C401, LYWSD02, ...
In connection mode, it has the ability to work as a repeater - scanner BLE advertising from other devices.
TelinkOTA - https://pvvx.github.io/UBIA/TelinkOTA.html
Install the Advertising type: "custom" on the custom firmware (https://github.com/pvvx/ATC_MiThermometer), Reed Switch (GPIO PA6 - label on the "P8" pin for LYWSD03MMC).
TLSR8266 Run AdScanerTrg.html and configure the MAC of the sensors devices
If sensor data is not received within 60 seconds, then GPIO_xx are set to "0".
TLSR825x Run AdScanerTrg2.html and configure the MAC, bindkey of the sensors devices
- Implementation on E104-BT05-TB and ESP01Relay:
