Universal Flash Programmer

This project aims at developing a flash programmer software supports various of flash chips through various controllers on various platforms.

Currently this project is at an early developing stage.

Pull requests are welcome.

Features

Controller plugin support. Easy to add new controller support.
Controller configuration. Supports configuration-specific features (multiple USB interface/drive strength/chip select/...).
Abstraction Layer: Controller <- -> Interface <- -> Flash device. Easy to add multiple interface support.
External Flash ID list support. Easy to add new flash without recompiling the project.
Cross-platform. Supports Windows and Linux.

SPI-NOR Features

SFDP parsing for new flashes.
Supports OTP regions.
Supports non-volatile register modification.
Supports write-protection modification.

Generic NAND Features

Supports ECC plugin to replace NAND's on-die ECC
Supports Bad Block Table (BBT) plugin
Supports simple Flash Translation Layer (FTL) plugin
Supports OTP regions.
Supports reading unique ID.

SPI-NAND Features

ONFI parameter page parsing for new flashes.

Supported controllers

WCH CH341 (100KB/s read)
WCH CH347 (4.9MB/s read)
FTDI MPSSE chips (FT232H/FT2232H/FT4232H) (3MB/s read)
FTDI FT4222H (6MB/s read using QSPI)
Programmer using serprog protocol (860KB/s read using USB FS)

Supported interfaces

SPI (Single/Dual/Quad/QPI using SPI-MEM)
TBD: I2C/Parallel NAND

Supported flash types

SPI-NOR
SPI-NAND
TBD: Parallel NAND/24 EEPROM

Supported SPI-NOR flashes

Atmel/Adesto/Dialog/Renesas
EON
ESMT
GigaDevice
Intel
ISSI
Macronix
Microchip/SST
Micron
Spansion/Cypress/Infineon
Winbond
XMC
XTX
TBD: FudanMicro/Puya/Zbit/Zetta...

Supported SPI-NAND flashes

Alliance Memory
ATO Solution
CoreStorage
Dosilicon
ESMT
Etron
Fidelix
FORESEE
Fudan Microelectronics
GigaDevice
HeYangTek
ISSI
Macronix
Micron
MK Founder
Paragon
Toshiba/Kioxia
Winbond
XTX
Zetta

Build Prerequisites

libusb
hidapi-libusb
json-c

Supported compilers

MSVC (Windows only. Suggested to use with vcpkg)
GCC (Windows (mingw) and Linux)

Install

Linux

git clone https://github.com/hackpascal/ufprog.git

cd ufprog

cmake -DCMAKE_BUILD_TYPE=None \
    -DBUILD_PORTABLE=OFF \
    -DCMAKE_INSTALL_PREFIX=/usr \
    -B build \
    -G Ninja

ninja -C build

ninja -C build install

Arch Linux

Installation can be done via AUR ufprog-git.

yay -Syu ufprog

License

For executable programs, GPL-2.0-only
For libraries, LGPL-2.1-only