Gets solar energy production, household consumption, and net household consumption from Enphase Enlighten.
$ virtualenv env
$ . env/bin/activate
$ pip install -r requirements.txt
$ python report.py --start 3/4/20 --end 4/2/20
off peak consumption (< 08:00) 383.2 kwh
super off consumption (< 16:00) 221.1 kwh
peak consumption (< 21:00) 218.8 kwh
off peak production (< 08:00) 9.3 kwh
super off production (< 16:00) 781.5 kwh
peak production (< 21:00) 97.2 kwh
off peak net (< 08:00) 373.9 kwh
super off net (< 16:00) -560.3 kwh
peak net (< 21:00) 121.5 kwh
Follow the Enphase API Quickstart and replace ENPHASE_APP_KEY, ENPHASE_USER_ID, and ENPHASE_SYSTEM_ID in the script to hook up your own system.
This script uses the SoCal Edison time of use 4-9 rate plan (TOU-D-4-9). Change OFF_PEAK_END_HR, SUPER_OFF_PEAK_END_HR, PEAK_END_HR for different rate plans.
I installed my own 6.8 kW solar panel system in 2019 to take advantage of the 30% federal tax credit before it dropped. Not including four weekends of labor, it cost $11,200 after the credit and will pay itself off in about five years.
I modeled my permit application after a friend's, which made the whole permitting ordeal considerably more tractable than it would otherwise have been. Even so, it took about sixteen hours to design my system and write my permit, which was — somehow? — stamped on my first try. Inspection was also unexpectedly straightforward: after glacing at my electrical panel, the inspector signed off without even going on my roof! He said, "all those guys do a good job anyway." I held my tongue.
It took another several hours to finish my permission-to-operate application with SoCal Edison (SCE) and opt into net metering and time-of-use billing, which is required for net metering clients. I got an unexpectedly high first bill; my energy is delivered by SCE but generated by Clean Power Alliance (CPA). CPA has a surplus of solar energy, so it charges a negative super off peak rate. After switching over to SCE for generation, my already-improved electrical bill improved by nearly $50 per month.
I built a trellis/ramp to make it easier to get twenty-one 50 lb panels on my roof.
It took an entire day for me to find rafters and plan my roof penetrations with sidewalk chalk.
Those boards on the rails on Enphase Microinverters.
Here's the roof part of the finished product!
Here's the ground part! The Enphase Envoy is on the left. It combines the two home runs from the roof, uses current transformers to monitor production and consumption, and reports those numbers at 15 minute intervals to the cloud.