temp_err not reset after entering pit mode
Closed this issue · 3 comments
john-k3nnedy commented
I see
temp_err = 1;
in a couple of places, for example after entering pit mode, which then applies a pwr_offset = 10
in PowerAutoSwitch()
, but don't see temp_err
revert to 0 anywhere.
This suggests there's always pwr_offset = 10
applied after having been in pit mode once.
ligenxxxx commented
This problem cannot be fixed for now, it is related to the dm6300 chip.
john-k3nnedy commented
This problem cannot be fixed for now, it is related to the dm6300 chip.
Do you have some details on this?
ligenxxxx commented
This problem cannot be fixed for now, it is related to the dm6300 chip.
Do you have some details on this?
Unfortunately no.