himalayanelixir/pi-ardiuno-communication

💬 Example of a Raspberry Pi and Ardiuno talking to each other

Pi Arduino Communication

• Instructions
  • Raspberry Pi
  • Arduino

The function of this code is to be able to pass messages between a Raspberry Pi and an Arduino. This setup has the Raspberry Pi as the master and the Arduino as a slave.

Instructions

Raspberry Pi

1. Requirements: Need Python 3 and pyserial. pyserial can be installed using pip.

   pip install -r Raspberry\ Pi/requirements.txt
   

2. You will likely have to modify the serPort = "/dev/cu.SLAB_USBtoUART" line in the code to match which port your Arduino will be located on.

3. Run

   python3 Raspberry\ Pi/controller.py
   

4. Enter commands using the format <Up,Down,Left,Right>. Currently the code is made to look for < > at the beginning and end of commands and different commands are separated by a comma.

Arduino

1. Open the project in the Arduino IDE by clicking on Arduino/Arduino.ino

2. There are 3 files in this project.

   • Arduino.ino - Contains the setup() and loop() functions
   • arduino_controller_functions.ino - This is where the magic happens. The ProcessData() function is where you will be adding logic to execute commands from the Raspberry Pi.
   • communications.ino - Contains the logic to communicate with the Raspberry Pi over serial.

3. Upload your code to the Arduino. Currently no matter what commands are sent to the Arduino it will flash the built-in LED and return a success message to the Raspberry Pi.