/beacon-monitoring

Primary LanguageJavaScript

Setup forever

  • sudo nano /start
  • Add following lines:
sudo forever stopall
cd /home/pi/beacon-monitoring
sudo su pi -c 'git fetch --all'
git reset --hard origin/master
sudo DEVICE="GATEWAY 1" forever start index.js
  • Change permissions: sudo chmod +x /start
  • sudo nano /etc/rc.local and add this line sudo sh /start
  • restart Raspberry

Setup Dataplicity

  • Run instalation script curl https://www.dataplicity.com/yliuqcp4.py | sudo python
  • Enable warm hole and set it to http://homoky-termostat-device.dataplicity.io/

Connect Relay 5V

Control side

  • UCC - pin 2
  • GND - pin 6
  • IN - pin 40

Controlling side

  • COM - connect cable under voltage (check manual of your device)
  • NO (normaly open - opened via Raspberry Pi) - connect cable for step-by-step (check manual of your device)
  • NC (normaly closed - at default) - do not use this one

Credentials