/fixhdd

hdd bad sectors fix utility

Primary LanguagePython

fixhdd

https://techoverflow.net/blog/2015/01/07/fixing-bad-blocks-on-hdds-using-fixhdd.py/

Fixing bad blocks on HDDs using fixhdd.py Mi 07 Januar 2015 By Uli Köhler In Python

Problem:

You hard drive or SMART tool reports errors when reading specific blocks similar to this message:

[3142.686141] end_request: I/O error, dev sda, sector 31415926 No matter how often you read the block, the hard drive still returns an error and does not reallocate the block.

Background:

Hard drives are programmed not to reallocate the block until someone writes to said block. This means that for normal users the program reading the bad block probably won’t fix the error by itself as most programs exhibit read-before-write usage patterns often resulting in a crash before any block is written. By using fixhdd.py, the script presented in this post, you can force your Linux-based OS to rewrite the blocks, effectively fixing the block errors if the HDD has reallocation space left. Usage of said script is only recommended for professional IT personnel.

Solution:

You can use this script, fixhdd.py in order to automatically write the blocks yielding errors. While the data stored in those blocks will be lost forever, you won’t any read error after writing to it.

Syslog monitoring mode

fixhdd.py operates in one of several modes including automatic sequential scan. The most straightforward mode, however, is to continously scan the system log for error message like that outlined above. The tool automatically extracts the LBA (logical block address) from the system log and writes it using hdparm (use sudo apt-get install hdparm or equivalent if not already installed).

In order to use this mode, run

sudo fixhdd.py --loop /dev/sda

in the background. In another shell, run the program yielding the error message repeatedly until the file can be read without an error. Every five seconds, fixhdd.py will re-scan the syslog and attempt to rewrite all damaged blocks. When finished, stop fixhdd.py using Ctrl+C.

Sequential block scan mode

After these errors are resolved, I recommend using smartctl -t [short|long] to run a SMART test on the hard drive (even a short two-minute tests will often yield a LBA for the first bad block). After the selftest has finished, use smartctl -a to find the first LBA of first error.

For this example, we will assume the LBA of first error is 1234567. To get the offset for fixhdd.py (i.e. the first LBA that will be scanned), substract a safety margin of about 100-1000 from the LBA of first error so the script will recognize errors occuring before the given LBA. The script will now try to read all LBAs starting from the offset, rewriting any bad blocks in the process. You can also start at offset 0 and wait several hours to days for the whole HDD to be scanned.

sudo fixhdd.py -a -o 1234000 /dev/sda

WARNING: fixhdd.py is EXTREMELY dangerous and might destroy all your data in just a few seconds. I recommend using it only if you understand the source code and know how the script and hdparm work. Even then it is your own responsibility if any of your data gets lots (in theory, there is a remote possibility of hdparm damaging your hardware, however I believe this is next to impossible). While I used fixhdd.py several times to fix broken computers in the past, it might have critical bugs on other systems. Even hardware damage is possible, considering the power of hdparm. fixhdd.py currently doesn’t include a simulation mode and silently bypasses the hdparm --yes-i-know-what-i-am-doing flag.