AEPIC Leak

This is the PoC implementation for the USENIX 2022 paper AEPIC Leak: Architecturally Leaking Uninitialized Data from the Microarchitecture by Pietro Borrello, Andreas Kogler, Martin Schwarzl, Moritz Lipp, Daniel Gruss, and Michael Schwarz.

AEPIC Leak is the first architectural CPU bug that leaks stale data from the microarchitecture without using a side channel. It architecturally leaks stale data incorrectly returned by reading undefined APIC-register ranges.

This README provides instruction on how to build and run the described attack. The total install time should be around 30 minutes.

0. Jumpstart: Run APIC Dump

We provide a simple kernel module that dumps the content of the APIC MMIO region. This confirms that the APIC leaks data on the machine tested.

$ cd src/apic_dump
$ make run

If your CPU is vulnerable, running the apic_dump you will observe spurious memory returned by the APIC, as opposed to 0x00 bytes.

NOTE: Make sure that the machine is booted in xAPIC mode, by providing nox2apic in the Linux kernel command line.

1. Dependencies

sudo apt install -y g++-11

build sgx-step SDK and library

git submodule init
cd sgx-step
cd sdk/intel-sdk/ && ./install_SGX_SDK.sh && source /opt/intel/sgxsdk/environment
cd libsgxstep && make && cd ..

2. Build

This step builds the Custom SGX Driver and the attack PoCs.

$ cd src
$ make

3. Load the Custom SGX Driver

$ cd src
$ make load

4. Run the experiments

Victim Enclaves

Victim runner to experiment:

aes: to leak Intel IPPC AES
egetkey: to leak seal key
memory: to leak simple memory content
rdrand: to leak rdrand content
rsa: to leak rsa private key
simple_ssa: to leak SSA region

Enclave Runner

Runs a victim enclave and waits for user input to terminate it:

cd src/runner
./runner ../enclaves/aes/enclave.signed.so

Enclave Dumper

Dumps the whole memory of an enclave by exploiting AEPIC Leak. Usage: ./dumper [enclave_pid] [enclave_idx] [flags] [dump_file] where flags: x=dump_code d=dump_data p=non_present s=show r=readable

E.g.,

./dumper `pidof runner` 0 dsr <output_file>

Enclave Stepper

Single steps an enclave until the required instruction, and then dumps the target registers by dumping the SSA page using AEPIC Leak.

sudo ./stepper <path_to_enclave> <print_readable> <path_to_config>

We use a configuration file to tell the stepper when to stop and what to dump. E.g. src/enclaves/aes/stepper_config.

hyoer0423/AEPIC