/K1-Config

Creality K1 Config files

Primary LanguagePython

Klipper Configurations for Creality K1 Printer

Note: Install only on the official firmware with root access!

Uploading Instructions:

  • Load these configurations through http://x.x.x.x:4408/#/configure or navigate to the 'Configuration' section in your printer's interface.

Fully Working Klipper Config for K1 with KAMP v8:

  • Fixed: (SMART_PARKING) OUT OF RANGE error.

  • Added: TIMELAPSE FOR MOONRAKER & KLIPPER (requires adding g-code in Orca printer settings, under Machine G-code (Before Layer change G-code). It should look like this:

    ;BEFORE_LAYER_CHANGE
;[layer_z]
G92 E0
TIMELAPSE_TAKE_FRAME

In Klipper Macros:

  1. Press the calibration macros in sequence.
  2. Sometimes, the console will ask to press SAVE_CONFIG — do it.

Before Starting Calibration:

Please, ensure the bed is in perfect condition, remove filament, and make sure the hotend is empty.

Calibration:

  • PID for the hotend (PID_HOTEND)
  • PID for the bed (PID_BED)
  • Input Shaper (INPUTSHAPER)
  • Leveling (BED_LEVELING)

Known Issues: