Simple PHP Code to automatically read and display DS18B20 names and temps to a php page on a raspberry pi.
####Instructions:
You will need to setup the pi to add OneWire support
Start by adding the following line to /boot/config.txt
You can edit that file with nano by running sudo nano /boot/config.txt
and then scroll to the bottom and type
dtoverlay=w1-gpio
press ctrl+x and y to confirm, then sudo nano /etc/modules
add the following 2 lines to the bottom:
w1-gpio
w1-therm
press ctrl+x and y to confirm , then reboot your pi. Add temp.php to /var/www/ then visit http://127.0.0.1/temp.php
Page output should look similar to this:
Sensor ID#: 28-0214640d18ff = 26 °C / 79 °F
Sensor ID#: 28-02146409b9ff = 25 °C / 77 °F