/netgear-enhanced-integration

Primary LanguagePython

Supported

The supported sensors are:

  • Firmware
  • App Firmware 🆕
  • Device Config 🆕
  • Access Control Status
  • Traffic Meter
  • Traffic Meter Enabled
  • Traffic Meter Opt
  • LAN Config 🆕
  • WAN Info 🆕
  • Parental Control Enabled
  • All MAC Addresses
  • DNS Masq
  • Info
  • Supported Features
  • Speed Test Result
  • QOS Enabled
  • Bandwidth Control
  • 2G Guest Wifi
  • 5G Guest Wifi
  • WPA Security Key
  • 5G WPA Security Key
  • 2G Info
  • 5G Info
  • Channel 🆕
  • 2G Guest Wifi Info
  • 5G Guest Wifi Info
  • Smart Connect 🆕

The supported switches are:

  • Access Control
  • Traffic Meter
  • Parental Control
  • QOS
  • 2.4g Guest WiFi
  • 5g Guest WiFi
  • Run Speed Test (switch will always toggle to off)
  • Reboot Router (switch will always toggle to off)

Setup

  • Create the netgear_enhanced folder in custom_components.
  • Copy the files to the netgear_enhanced folder.

For sensors

  • Place the following code in your config under sensor:
    • Make sure to modify the parameters to fit your needs. It may cause some strain to have too many sensors polling data.
  - platform: netgear_enhanced
    host: !secret my_secret_ip
    username: !secret my_secret_netgear_user
    password: !secret my_secret_netgear_pass
    resources:
      - firmware
      - check_app_fw
      - get_device_config_info
      - access_control_on
      - traffic_meter
      - traffic_meter_on
      - traffic_meter_options
      - get_lan_config_info
      - get_wan_ip_info
      - parental_control_on
      - mac_address
      - dns_masq
      - info
      - supported_features
      - speed_test_result
      - qos_enabled
      - bw_control
      - 2g_guest_wifi_on
      - 5g_guest_wifi_on
      - 2g_wpa_key
      - 5g_wpa_key
      - 2g_wifi_info
      - 5g_wifi_info
      - get_channel
      - 2g_guest_wifi_info
      - 5g_guest_wifi_info
      - get_smart_conn

For switches

  • Place the following code in your config under switch:
    • Make sure to modify the parameters to fit your needs. There may be some delay in updating the switch due to the router changing configuration.
  - platform: netgear_enhanced
    host: !secret my_secret_ip
    username: !secret my_secret_netgear_user
    password: !secret my_secret_netgear_pass
    resources:
      - 'access_control'
      - 'traffic_meter'
      - 'parental_control'
      - 'qos'
      - '2g_guest_wifi'
      - '5g_guest_wifi'
      - 'run_speed_test'
      - 'reboot'