This is a "plugin" for the Video Disk Recorder (VDR). Written by: Jochen Dolze <vdr@dolze.de> Project's homepage: http://projects.vdr-developer.org/projects/show/plg-markad Latest version available at: http://projects.vdr-developer.org/projects/plg-markad/files This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or (at your option) any later version. See the file COPYING for more information. Description: MarkAd marks advertisements in VDR recordings. Command line options: A few settings are given on the command line rather than in the setup menu. Available options: -b DIR, --bindir=DIR use DIR as location for markad executable (default: /usr/bin) -l DIR --logocachedir=DIR use DIR as location for markad logos (default: /var/lib/markad) --astopoffs=SECONDS assume stop of the recording SECONDS after the end of the EPG time. default is 100 s If end marks are to early, try to add some seconds --cDecoder use the alternative decoder --cut cut video based on marks and write it in the recording directory requires --cDecoder there are no splits of the target file, make sure your filesystem can handle big files --ac3reencode re-encode AC3 stream to fix low audio level of cutted video on same devices requires --cDecoder and --cut --autologo=<option> 0 = disable, only use logos from logo cache directory (default) 1 = enable, if there is no suitable logo in the logo cache directroy find logo from recording and store it in the recording directory memory usage optimized operation mode, but runs slow 2 = enable, if there is no suitable logo in the logo cache directroy find logo from recording and store it in the recording directory speed optimized operation mode, but needs a lot of memonry, use it only > 1 GB memory If this option is set you can not configure this feature from the VDR menue If you use the alternative decoder these are the recommended plugin default settings. This parameters will pass through to the markad command. Put these lines into your markad plugin configuration, usually stored in /etc/vdr/conf.d: [markad] --astopoffs=0 --cDecoder To report bugs please execute markad with the following command line parameters: markad --loglevel=3 --astopoffs=0 --cDecoder --log2rec nice <path to recording> Post the files markad.log, marks und info from the recording directory at https://www.vdr-portal.de.