/semver-compare-cli

CLI wrapper of the semver-compare library

Primary LanguageJavaScriptMIT LicenseMIT

semver-compare-cli

standard-readme compliant

CLI wrapper of the semver-compare library

Compare two semver version strings on the command line. The exit code is 0 (equal), 1 (greater), or 2 (smaller). In addition, a predicate can be added that's applied when comparing the two version.

The project is a wrapper around the semver-compare library.

Table of Contents

Install

Install via npm:

yarn global add semver-compare-cli

or use deno to run it without installation:

deno run https://cdn.deno.land/semver_compare_cli/versions/v2.0.0/raw/semver-compare.js

Usage

Direct comparison

For a direct comparison of two versions the following exit codes are possible:

  • 0 versions are equal
  • 1 the first version is larger than the second version
  • 2 the first version is smaller than the second version

Example, exit code is 2 because the first version is smaller than the second version:

semver-compare 1.0.0 1.0.1

Comparison with predicate

For a comparison with a predicate the following exit codes are possible:

  • 0 predicate applies to the comparison of the two version
  • 1 predicate doesn't apply

The following predicates are supported that shall be placed between the two version numbers:

  • eq: equal
  • ge: greater than or equal
  • gt: greater than
  • le: lower than or equal
  • lt: lower than

Example, exit code is 1 because the first version is smaller than the second version:

semver-compare 1.0.0 ge 1.0.1

Maintainers

@jceb

Contributing

PRs accepted.

Small note: If editing the README, please conform to the standard-readme specification.

License

MIT © 2021 Jan Christoph Ebersbach jceb@e-jc.de