Personal keymaps for the various keyboards I have/use. These are all based on QMK/TMK. Previously I used TMK for all of them but eventually switched to QMK. This uses docker for building the images to keep the build platform consistent.
ex.
$ make kc60
...
$ ls kc60/firmware.hex
kc60/firmware.hex
$ make flash-kc60
...
For each of the keyboards, there are two major make targets, the flat
make <keyboard_name> which will build the firmware as a hex file that
will be created in the folder. Then there is a helper make flash_<keyboard_name> that will do the flashing. It will require sudo
rights, so it will prompt for input if required, then wait some time for
you to put the board into a flashable state, then do the steps to flash
the local firmware onto the board and restart it.