jerabaul29/OpenMetBuoy-v2021a

Issues

• DS18B20: order based on the full 64-bit ID

  #101 opened 3 months ago by jerabaul29
  0

• use a better way to order the DS18B20s and transmit their IDs using persistent memory?

  #100 opened 3 months ago by jerabaul29
  0

• when generating the 6-bit IDs for the DS18B20, use the most significant of the least significant bits so that ordering is the same as if taking the full ID

  #99 opened 3 months ago by jerabaul29
  0

• default values on the thermistor packets

  #95 opened 8 months ago by jerabaul29
  0

• about the DS18B20

  #93 opened 10 months ago by jerabaul29
  3

• version without qwiic switch for UTokyo

  #97 opened 4 months ago by jerabaul29
  5

• version without qwiic switch for GauteH

  #98 opened 4 months ago by jerabaul29
  19

• extend the assembly instructions

  #96 opened 5 months ago by jerabaul29
  1

• extra sensors

  #94 opened 8 months ago by jerabaul29
  1

• Found a clean circuit board

  #92 opened 10 months ago by tindelan
  1

• acceleration orientation is actually up, not down

  #91 opened 10 months ago by jerabaul29
  0

• test use of batteries with U-solder tags

  #90 opened a year ago by jerabaul29
  0

• adding criteria to push to buffer when there is no wave signal (for large number of OMBs on fast ice to cut Iridium cost).

  #89 opened a year ago by tnn77
  4

• Add test bench to check the ID of thermistors

  #88 opened a year ago by jerabaul29
  1

• write guide for people using the OMB from Labmaker

  #76 opened a year ago by jerabaul29
  9

• Robustify qwiic switch start

  #87 opened a year ago by jerabaul29
  0

• Update generated nc files to report CF-convention-compatible name for the wave spectrum

  #86 opened a year ago by jerabaul29
  0

• data displaying using OceanDataLab Syntool

  #71 opened 2 years ago by jerabaul29
  2

• investigate lower power GPS module for future iterations of OMB with GPS waves measurements

  #85 opened 2 years ago by jerabaul29
  0

• docker container to compile the arduino sketch

  #83 opened 2 years ago by jerabaul29
  4

• netCDF: obs dimension name

  #66 opened 2 years ago by jerabaul29
  2

• netCDF: GPS vs wave obs?

  #67 opened 2 years ago by jerabaul29
  2

• netCDF: add version

  #68 opened 2 years ago by jerabaul29
  2

• custom firmware version

  #79 opened 2 years ago by jerabaul29
  0

• make sure the battery is well maintained in place! especially for instruments going into rough seas!

  #84 opened 2 years ago by jerabaul29
  0

• use with solar panel

  #82 opened 2 years ago by jerabaul29
  0

• terminology

  #81 opened 2 years ago by jerabaul29
  0

• decoder: sometimes wave message has datetime_fix, sometimes datetime_packet

  #80 opened 2 years ago by gauteh
  8

• bad fixes: ```lat == lon == 0```: catch and ignore

  #78 opened 2 years ago by jerabaul29
  1

• reduce iridium costs: make sure packets are "just under multiple of 50 bytes"

  #77 opened 2 years ago by jerabaul29
  0

• updates based on current series

  #75 opened 2 years ago by jerabaul29
  2

• add kicad drawing from Susanne?

  #74 opened 2 years ago by jerabaul29
  1

• implement low frequency dynamic cutoff for open water deployments

  #73 opened 2 years ago by jerabaul29
  5

• deceiving name of fft_overlap variable

  #72 opened 2 years ago by jerabaul29
  0

• antenna cable, impedance, and L-shaped connector

  #64 opened 2 years ago by jerabaul29
  8

• TODO: updates

  #70 opened 2 years ago by jerabaul29
  1

• alternative magnetic switch

  #69 opened 2 years ago by jerabaul29
  2

• utils: automatic creation of netcdf files

  #65 opened 2 years ago by jerabaul29
  1

• wavebug plotter: add link and explanations to Gaute's solution

  #57 opened 3 years ago by jerabaul29
  2

• standard set of scripts and tools for data collection: use the AWI deployment code when "battle tested"

  #59 opened 2 years ago by jerabaul29
  2

• GND on qwiic switch: is it exactly the same on both sides?

  #63 opened 2 years ago by jerabaul29
  1

• parser script not working on Windows

  #53 opened 3 years ago by jerabaul29
  5

• Alternatives to core component (Artemis Global Tracker)?

  #52 opened 2 years ago by AndresSepulveda
  14

• Binary for measuring waves every hour

  #60 opened 2 years ago by bjorkqvi
  5

• ISM330DHCX as a SF qwiic breakout

  #61 opened 2 years ago by jerabaul29
  4

• Size of buffer

  #62 opened 2 years ago by bjorkqvi
  1

• PCBs: labmaker / UTokyo

  #58 opened 3 years ago by jerabaul29
  0

• plots: maps: add "dotted line" when long time with no transmission

  #56 opened 3 years ago by jerabaul29
  0

• plots: maps: add a red cross when no transmission in the last 24 hours for a buoys

  #55 opened 3 years ago by jerabaul29
  0

• add search and rescue image

  #54 opened 3 years ago by jerabaul29
  0