jjkirkpatrick/reef-mon

A Reef monitoring solution written in GO using InfluxDB as a data store

Reef-Mon

Reef-Mon is a simple tool to monitor the status of a Reef using Go, InfluxDB and a Raspberry PI.

Requirments

Go: https://golang.org/ InfluxDB: https://influxdb.com/

Installation

Clone the repository and run the following command to start the application:

make run-dev

This will build the application and start it.

To list all temperature sensors run the following:

cd reef-mon/commands
go run . list-temperature-devices

Configuration

InfluxDB is used to store the data. The following configuration is required:

influxDB:
  host: "http://localhost"
  port: "8086"
  token: "mzf...kUWg=="
  bucket: "reef-mon"
  org: "reef-mon"

The below configuration is an example of how to configure a monitor.

Name: The name of the monitor, this is used to identify the monitor in the database.

Mesurment: The name of the measurement in the database.

Field: The mesurment field name.

Interval: The interval in seconds used to poll for data.

Type: Yaml representation of the monitor type and confiuration
type: name: "gpio_switch" pin: 22

monitors:
  lowWater1:
    name: "WaterLow"
    measurement: "water_low"
    field: "status"
    interval: 10
    type:
      name: "gpio_switch"
      pin: 22
      active_low: true  
    influx:
      bucket: "reef-mon-water-level"
  temperature1:
    name: "temperature 1"
    measurement: "water_temperature"
    field: "temperature"
    interval: 5
    type:
      name: "1w_temperature"
      deviceid: 28-01211358c5ab
    influx:
      bucket: "reef-mon-water-temperature"

Contributing