using 0.15mm feeler gauge
G28
BED_MESH_CLEAR
QUAD_GANTRY_LEVEL
G28
G1 X150 Y150 Z1 F6000
Z_ENDSTOP_CALIBRATE
- https://mellow.klipper.cn/#/advanced/usb_adxl
- https://github.com/VoronDesign/Voron-Stealthburner/blob/main/STLs/Stealthburner/ADXL345_Mounts/sb_adxl_mount_generic_15.5mm_c_c.stl
sudo service klipper stop
cd ~/klipper
make clean
make menuconfig
make
make flash FLASH_DEVICE=/dev/serial/by-id/$(ls /dev/serial/by-id/ | grep stm32f446)
sudo service klipper start
- Voron parts were printed with ABS+Glass Fiber filament from Phaetus
- Printer -> Machine G-code
- Matchine start G-code (add):
PRINT_START EXTRUDER=[nozzle_temperature_initial_layer] BED=[bed_temperature_initial_layer_single] Chamber=[chamber_temperature] PRINT_MIN={first_layer_print_min[0]},{first_layer_print_min[1]} PRINT_MAX={first_layer_print_max[0]},{first_layer_print_max[1]}
- Layer change G-code:
M117 Layer {layer_num+1}/[total_layer_count] : {filament_settings_id[0]}
- Matchine start G-code (add):
- Layer height: 0.2 mm
- Line width -> Default: 0.4 mm
- Infill percentage: 40%
- Infill type: grid
- Wall count: 4
- Solid top/bottom layers: 5
- Supports: NONE
journalctl -u klipper.service
# if c_helper.so
rm -rf /home/biqu/klipper/klippy/chelper/c_helper.so