/OctoPrint-PrintTimeGenius

Use a gcode pre-analysis to provide better print time estimation

Primary LanguagePython

OctoPrint-PrintTimeGenius

Crowdin

Provide better estimations on print time in OctoPrint.

In the chart, we see that the print time remaining is never off by more than 3 minutes using the GeniusEstimator, under 3%. The estimator built-in to OctoPrint is off by 19 minutes at worst, which is a 16% error.

total time graphs in minutes actual vs estimated vs geniusestimator

Setup

Install via the bundled Plugin Manager or manually using this URL:

https://github.com/eyal0/OctoPrint-PrintTimeGenius/archive/master.zip

Configuration

After first installing, you should test that it works by going into settings and analyzing a file. Then look at the log and make sure that there are no errors. If you see errors, report them here.