Build instructions ================== First, specify the platform and toolchain configurations for the project: cd /path/to/OSELAS.BSP-EnergyMicro-Gecko ptxdist select configs/ptxconfig ptxdist platform configs/platform-energymicro-efm32gg-dk3750/platformconfig ptxdist toolchain <path_to_toolchain_bin_dir> where <path_to_toolchain_bin_dir> is /opt/ex3/OSELAS.Toolchain-2012.12.0/arm-cortexm3-uclinuxeabi/gcc-4.7.2-uclibc-0.9.33.2-binutils-2.22-kernel-3.6-sanitized/bin for the TDT4258 virtual machine. You can ignore the "no toolchain found" error on the third step. Finally, to build the flashable images, issue: ptxdist images This takes some time now. After ptxdist is completed and you plugged your Gecko board to your machine, first make sure that the debug mode is set to "MCU". (Press the "CFG" button under the display, then select "MCU" for "Debug Control" and save.) Then you can do ptxdist test flash-all to write the built images into the Gecko's flash and boot into Linux. Note that this uses Energymicro's eACommander which needs 32-bit Qt installed. See the compendium for more detailed information.