Emitter LED

[4cho]

Dear Jpiat,

How did you connect wires to the emitter LED and how many arduino mini is need in emitter circuit? I am using the same emitter LED like you but i can't figure out how to connect to the arduino. Actually, I cant see any pin on emitter LED.

[jpiat]

Each code (receiver code and emitter code) has a ASCII drawing on how to connect the led at its top. For the emitter, you'll need one arduino, wired to a led through a current limiting resistor, and for the receiver, another arduino with a led wired to an analog port with a parallel led. Jonathan Piat Le 24 févr. 2017 6:10 PM, "4cho" <notifications@github.com> a écrit :

…

Dear Jpiat, How did you connect wires to the emitter LED and how many arduino mini is need in emitter circuit? I am using the same emitter LED like you but i can't figure out how to connect to the arduino. Actually, I cant see any pin on emitter LED. — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#23>, or mute the thread <https://github.com/notifications/unsubscribe-auth/ACNWZJwJoe1xS4bVHf5Q_Q_4ZTys4pQdks5rfw8IgaJpZM4MLctv> .

[4cho]

First of all, thanks for your replay, Jonathan. I saw the ASCII drawing and it is really helpful. For the emitter LED, did u drilled or open the LED to connect the wire inside because I bought the LED which is AC power supply since I can't find another emitter LED like the one you are using.

[jpiat]

You first need to use a plain old 5 or 3mm led dot not start with a LED bulb. To use a LED bulb, i had to make major modifications to it. 2017-02-24 18:28 GMT+01:00 4cho <notifications@github.com>:

…

First of all, thanks for your replay, Jonathan. I saw the ASCII drawing and it is really helpful. For the emitter LED, did u drilled or open the LED to connect the wire inside because I bought the LED which is AC power supply since I can't find another emitter LED like the one you are using. — You are receiving this because you commented. Reply to this email directly, view it on GitHub <#23 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/ACNWZKFCy3xHyvqze13QerTCz1gAJ33zks5rfxMngaJpZM4MLctv> .

[4cho]

OH... I see. I was trying to figure out how to use that led bulb. 😆 Thank you for your advise, sir. 👍

[inwan96]

@4cho have you found a way to use a led bulb in transmitter ?
because my project use a led bulb sir @jpiat

[4cho]

for the time being, I am using such the LED in the link below.
http://resource.led-purchase.com/upload/g/20120821/09252241.jpg