.: :,
,:::::::: ::` ::: :::
,:::::::: ::` ::: :::
.,,:::,,, ::`.:, ... .. .:, .:. ..`... ..` .. .:, .. :: .::, .:,`
,:: ::::::: ::, ::::::: `:::::::.,:: ::: ::: .:::::: ::::: :::::: .::::::
,:: :::::::: ::, :::::::: ::::::::.,:: ::: ::: :::,:::, ::::: ::::::, ::::::::
,:: ::: ::: ::, ::: :::`::. :::.,:: ::,`::`::: ::: ::: `::,` ::: :::
,:: ::. ::: ::, ::` :::.:: ::.,:: :::::: ::::::::: ::` :::::: :::::::::
,:: ::. ::: ::, ::` :::.:: ::.,:: .::::: ::::::::: ::` :::::::::::::::
,:: ::. ::: ::, ::` ::: ::: `:::.,:: :::: :::` ,,, ::` .:: :::.::. ,,,
,:: ::. ::: ::, ::` ::: ::::::::.,:: :::: :::::::` ::` ::::::: :::::::.
,:: ::. ::: ::, ::` ::: :::::::`,:: ::. :::::` ::` :::::: :::::.
::, ,:: ``
::::::::
::::::
`,,`
http://www.thingiverse.com/thing:1679838
Servo Mount by AlexGale is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/
# Summary
Mounts a Tower Pro 9 gram micro servo.
And a Fitec 9 gram continuous micro servo.
Use two sheet-metal Phillips oval 4 x 3/4 screws to secure the servo to the mount (see picture above).
The mount gets secured to a base by three M3 * 5 mounting screws.
# Print Settings
Printer Brand: Printrbot
Printer: Simple Black
Rafts: No
Supports: No
Resolution: fine
Infill: 15%
Notes:
how I printed it, the base it was breaking a bit, so I recommend a higher Infill to prevent breaking.
# Post-Printing
the inside was breaking a little bit (needs more infill)
# Instructions
1) feed the 3 pin female connector through the rectangular hole from the inside.
2) Push the servo in by the front.
3) screw the servo in place by two long thin screws.
4) secure the base in place by three M3 * 5 mounting screws.