进度
- 基于 xdebug2.7(https://github.com/xdebug/xdebug), 目前修改基本完毕了
- QQ 群: 897623858
注意事项
- 为了避免 swoole 的检测 xdebug 警告, 扩展注册的名称是 sdebug, 如果想使用 Phpunit CodeCoverage , 需要手动把检测 xdebug 的判断修改成 sdebug
- 单步调试: 如果php不是7.3的, 建议使用 sdebug_2_6(https://github.com/mabu233/sdebug/tree/sdebug), sdebug_2_7 可能需要与phpstorm2019搭配使用
Clone
You can clone the Sdebug source directory with:
git clone https://github.com/mabu233/sdebug.git
Then move into this new directory:
cd sdebug
Compile
If PHP is installed in a normal, and uncomplicated way, with default locations and configuration, all you will need to do is to run the following script:
./rebuild.sh
This will run phpize
, ./configure
, make clean
, make
and make
install
.
The long winded way of installation is:
Run phpize:
phpize
(or/path/to/phpize
if phpize is not in your path)../configure --enable-xdebug
(or:../configure --enable-xdebug --with-php-config=/path/to/php-config
ifphp-config
is not in your path)Run:
make clean
Run:
make
Run:
make install
Add the following line to
php.ini
(which you can find by runningphp --ini
, or look atphpinfo()
output):zend_extension="xdebug.so"
.Please note, that sometimes the
php.ini
file is different for the command line and for your web server. Make sure you pick the right one.Unless you exclusively use the command line with PHP, restart your webserver.
Write a PHP page that calls
phpinfo();
. Load it in a browser and look for the info on the Xdebug module. If you see it, you have been successful! Alternatively, you can runphp -v
on the command line to see that Xdebug is loaded:$ php -v PHP 7.2.0RC6 (cli) (built: Nov 23 2017 10:30:56) ( NTS DEBUG ) Copyright (c) 1997-2017 The PHP Group Zend Engine v3.2.0-dev, Copyright (c) 1998-2017 Zend Technologies with Sdebug v2.x.x-dev, Copyright (c) 2002-2017, by Derick Rethans