Cepstrum Keyboard Case

3D-Print Files

There are two different sets of 3D-printed parts available.

Enclosed Case

One is a two-piece print for each half that consists of a top shell that goes over the switch plate, and a middle layer that goes between the switch plate and bottom plate. The files for this can be found in the enclosed directory.

The top shell has an angled front lip that can be hard to print well using an FDM printer, so the top shell pieces are better done using a resin printer.

You will need M2 8mm screws to insert through the bottom plate up to the top shell.

Mid-Only Case

The other option is just a middle layer. The switch plate will slot into this middle layer. You can just use the 6mm standoffs and 4mm screws that come with the Cepstrum plate kit with this piece. The files for this can be found in the mid-only directory.

Plate Files

Plate files are in the plates directory. They are designed to be 1.2mm thick.

License