Original Prusa i3 MK2 Firmware
General instructions
Pre-compiled hex output on PRUSA RESEARCH site: http://prusa3d.com/downloads/firmware/
Just download and flash it to the electronics
Build instructions
Step 1
Install arduino
Step 2
Remove Liquid Crystal library from your arduino or rename it
Step 3
Install the arduino addon located in the root of this repo. Don't forget to install correct version!
Step 4
Copy the configuration file matching your printer from variants folder to the the Firmware folder
Step 5
Rename it to "Configuration_prusa.h"
Step 6
Compile the firmware
Step 7
Upload the firmware to board