kiasarecool/HA_dht11_pir_oled_sensor_display

For Home Assistant

For Home assistant + espHome

• Use a dev board not a mini for best results
• STL made to fit nodemcu v3 esp8266

<SPECIFY_YOUR_PIN> numbers in config (gpio numbers not numbers printed on board)

Parts:

•Nodemcu v3 esp8266 •Dht11 •PIR sensor •10 female to female DuPont wires •A little duct tape 😉 •3d printed case (stl provided here) •SSD1306 0.96” Oled (i2c)