Bindings for i2c-dev. Plays well with Raspberry Pi and Beaglebone.
$ npm install i2c
var i2c = require('i2c');
var address = 0x18;
var wire = new i2c(address, {device: '/dev/i2c-1'}); // point to your i2c address, debug provides REPL interface
wire.scan(function(err, data) {
// result contains an array of addresses
});
wire.writeByte(byte, function(err) {});
wire.writeBytes(command, [byte0, byte1], function(err) {});
wire.readByte(function(err, res) { // result is single byte })
wire.readBytes(command, length, function(err, res) {
// result contains a buffer of bytes
});
wire.on('data', function(data) {
// result for continuous stream contains data buffer, address, length, timestamp
});
wire.stream(command, length, delay); // continuous stream, delay in ms
$ sudo vi /etc/modules
Add these two lines
i2c-bcm2708
i2c-dev
$ sudo vi /etc/modprobe.d/raspi-blacklist.conf
Comment out blacklist i2c-bcm2708
#blacklist i2c-bcm2708
Load kernel module
$ sudo modprobe i2c-bcm2708
$ sudo modprobe i2c-dev
Make device writable
sudo chmod o+rw /dev/i2c*
Set correct device for version
new i2c(address, device: '/dev/i2c-0') // rev 1
new i2c(address, device: '/dev/i2c-1') // rev 2
$ ntpdate -b -s -u pool.ntp.org
$ opkg update
$ opkg install python-compile
$ opkg install python-modules
$ opkg install python-misc
$ npm config set strict-ssl false
$ npm install i2c
- bonescript https://github.com/jadonk/bonescript/
- ADXL345 https://github.com/timbit123/ADXL345
- HMC6343 https://github.com/omcaree/node-hmc6343
- LSM303 https://github.com/praneshkmr/node-lsm303
- MPU6050 https://github.com/jstapels/mpu6050/
- MCP3424 https://github.com/x3itsolutions/mcp3424
- blinkm https://github.com/korevec/blinkm
- click boards https://github.com/TheThingSystem/node-click-boards
- more: https://www.npmjs.org/browse/depended/i2c