/xLoader

Tool for Flashing ☒CC01 and ☒CR0x using ☒IP01

MIT LicenseMIT

xLoader

Microsoft Windows Tool for Flashing ☒CC01 and ☒CR03 using ☒IP01

No tools available at this point for other Operating Systems!

Flashing Steps:

  1. Download xLoader.zip file.
  2. Virus Check the xLoader.zip file
  3. Unzip the xLoader.zip file
  4. Connect ☒IP01 and ☒CC01/☒CR03 together
  5. Insert ☒IP01 and ☒CC01/☒CR03 into an available USB port
  6. Wait for eventual drivers to be installed, if driver installation fail, goto USB Driver
  7. Execute the xLoader.exe file
  8. Choose Firmware. There is a .hex file included in the install folder. You can also download a specific radio ID pairs.
  9. Choose your COM port. If no COM port is available, goto USB Driver
  10. Click Upload
  11. Wait for the text Uploading... to be replaced by <nnnn> bytes uploaded
  12. Unplug ☒IP01 and ☒CC01/☒CR03

USB Driver

If you have issues with USB drivers for the ☒IP01, then go here ☒IP01, and install the driver from the drivers folder.

Flashing on Non-Windows Operating Systems

These instructions are provided AS IS. If you encounter difficulty, use the instructions above before reporting an issue.

  1. You will need to install the avrdude command. On several linux systems this is provided as a package through your package manager (e.g. sudo apt install avrdude).
  2. Execute the following command if ☒IP01 is connected at /dev/ttyUSB0: avrdude -p m328p -b 57600 -P /dev/ttyUSB0 -c stk500v1 -U flash:w:CR03_BootCamp_Firmware_V1.200_20170812.hex

License

See the LICENSE "MIT License” file for license rights and limitations (MIT).