This program enables GSM 0710 multiplexing using linux n_gsm line dicipline. Supported are also SIM900 and Telit modules.
This program :
- Opens modem device on serial line
- Enables modem CMUX
- Attaches n_gsm line dicipline
- Creates virtual TTYs
- Daemonizes and waits for signal
- Removes the virtual TTYs
In order to activate the CMUX mode the program sends some AT commands. Theses commands are mainly vendor specific and should be adapted to your own modem. The example in this code works for the Quectel M95 GSM module.
- In order to run this program you should have
n_gsmmodule built for your linux kernel and loaded. Usemodprobe n_gsmto load it. If it fails you probably have to build the kernel module by yourself. - Change the defined options in
cmux.c:
$ ./cmux -h
Usage: cmux --device /dev/ttyUSB0 --speed 115200
--type <type> SIM900, TELIT or default. (Default: default)
--device <name> Serial device name. (Default: /dev/ttyUSB0)
--speed <rate> Serial device line speed. (Default: 115200)
--mtu <number> MTU size. (Default: 512)
--debug [1|0] Enable debugging. (Default: 1)
--daemon [1|0] Fork into background. (Default: 1)
--driver <name> Driver to use. (Default: gsmtty)
--base <name> Base name for the nodes. (Default: /dev/ttyGSM)
--nodes [0-4] Number of nodes to create. (Default: 1)
- Change the AT commands set to fit your modem in
cmux.c. - Call make and run the program.
make
./cmux
It will create up to four devices:
- /dev/ttyGSM1
- /dev/ttyGSM2
- /dev/ttyGSM3
- /dev/ttyGSM4
You should now be able to access your modem with four TTYs and both use ppp and send AT commands to your modem.
This program is mainly an actual implementation of GSM 0710 tty multiplexor HOWTO
CC0