SPI OLED Example
This example uses the ESP8266 hspi Master to drive 0.96-inch SPI OLED, and the OLED driver chip is SSD1306.
How to use example
Hardware Required
- Connection:
Signal | Oled | ESP8266 |
---|---|---|
3.3V | VCC | VCC |
SCLK | D0(SCL) | GPIO14 |
D/C | DC | GPIO12 |
MOSI | D1(SDA) | GPIO13 |
RST | RES | GPIO15 |
CS | CS | GND |
GND | GND | GND |
Configure the project
make menuconfig
- Set serial port under Serial Flasher Options.
Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
make -j4 flash monitor
(To exit the serial monitor, type Ctrl-]
.)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
Example Output
- LOG:
I (233) spi_oled: init gpio
I (235) gpio: GPIO[12]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 1| Pulldown: 0| Intr:0
I (239) gpio: GPIO[15]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 1| Pulldown: 0| Intr:0
I (251) spi_oled: init hspi
I (257) spi_oled: init oled