/monjolo

Energy-harvesting sensors that meter based on recharge rate.

Primary LanguageEagle

Monjolo

Monjolo sensors are designed to meter energy consumers, such as plug loads, lighting, water heaters, etc. Monjolo exploits an interesting fact to accomplish this: energy consuming loads (e.g. overhead lighting) often produce side channels of energy that can be harvested (e.g. light with a solar panel). Monjolo nodes use an energy-harvesting power supply to scavenge energy from these side channels to power themselves. The sensors then infer information about the original load based on the rate it is able to harvest. Monjolo nodes follow a simple principle: the faster the rate of harvesting the greater the amount of energy consumed by the monitored load.

The operation of a Monjolo node proceeds as follows: the harvester charges a capacitor to some threshold. Once the threshold is met, the processing core of the node activates and transmits a packet. The capacitor is then drained to a lower threshold where the processing core is disabled and the recharging process recommences. A central receiver collects all of these packets and calculates the activation rate of the Monjolo node. This rate is then used to meter the energy consumer.

This differs from traditional sensing because there is no explicit sensor on the device. The sensing apparatus is entirely composed of the energy-harvester and the packet receiver. All information is contained in the rate of activations of the Monjolo node.

We have developed Three instantiations of this metering design. First is Coilcube, a power meter for AC loads. Second is a light sensor for metering lighting. And third is a thermoelectric design for metering temperature differential.

Coilcube

cc_case cc_open

Coilcube is an AC power meter that comes in two forms: plug-load and split-core.