Prusa Mendel Please read http://reprap.org/wiki/Hacklab_RepRap before attempting to build this. When checking out from git, run the following to check out the MCAD dependencies: git submodule init git submodule update Frame vertexes are based on Viks and Tonokips ones Prusa Mendel part list: To print: 6x frame-vertex 2x coupling 3x endstop-holder 1x x-carriage 1x x-end-idler 1x x-end-motor 2x z-motor-mount 4x belt-clamp 8x bar-clamp 2x rod-clamp 1x y-motor-bracket 2x pulley 3x pla-bushing The Mendel build plate contains all the parts except the pla bushings Vitamins required: 5/16 threaded rods - Measure these by assembling your parts to the build size you need and then figure out how long the rods need to be. (this sucks i know.. it's beta ;) 5/16 smooth rods - same 5/16 nuts - allot? I'd say 50-75? some zip ties teflon bushings screws for your motors 4x nema 17 stepper motors 2x XXmm x 5mm T5 pitch timing belt